Yann's Techno Toys Blog
Yann's Planes
Hobby Picture Gallery
Bertrand's Site
E-Flight Links
Planes
PMAV
Engine Sound Synth
Naboo Cruiser
A.D.V.E.R.S.E.
NanoMate
NanoSaucer
X-15
TurboWraith
Horreur 4
Drenalyns/PacMan
Zepron FunFly
PicoSpit
R/C AirHog
Horreur
Delta Depron
Techniques
Depron/Zepron
Minicam
Battery Data
Motor Data
Galleries
Lots of Planes
Failures
Huge Picture Gallery
yann.lecun.com
lecun.org
Download the DjVu Plugin
DjVu
Radio Controled Air Hog

This is a radio controled ultra-light park flyer built around a compressed-air engine taken out of an "Air Hog" toy plane. The engine runs for about 20 seconds.

The wings are formed of two 400mm by 150mm rectangles of 6mm Depron glues together with 5minute epoxy. The undercambered airfoil is obtained by holding the wings in shape while heating them with a heat gun.

Yann with his Radio Controled Air Hog. Total mass: 170 grams; Wingspan: 800mm; length: 500mm.
Yann's brother, Bertrand with the plane. The wings and tail are made of 6mm Depron. The fuselage is a 6mm carbon tube.
Frontal view showing the 250mAh radio battery. A smaller battery could be used to reduce weight. Wing loading is 14.2g per square decimeter.
View showing the air tank and the receiver (the little red rectangle underneath the tank. The Radio is a Hitec feather 3 channel with two HS-55 submmicro servos
A 1.37MB MPEG movie showing a flight in a gymnasium in Saint-Meloir des Ondes, near Mont Saint-Michel. Yann is flying the plane.
This time, Yann's dad Jean-Claude is flying the plane (1.04MB MPEG).
A soft landing followed by much rejoicing from the crowd (550KB MPEG)
The vertical fin caught a cable hanging from the ceiling. The plane sat there for 5 minutes until someone shot it down with a roll of scotch tape. The cable had made a 10mm notch in the fin.
A movie of another version of the R/C AirHog (slightly larger wingspan).

Send comments and questions to Yann: .